Going to replace my header gasket on a 78 280Z with F/I. What is the proper torque setting of the bolts, and is there a certain procedure for tightening them down.
Going to replace my header gasket on a 78 280Z with F/I. What is the proper torque setting of the bolts, and is there a certain procedure for tightening them down.
Don't know the torque settings. Put em on with a wrench pretty tight. Its good to put some good lubricating **** on the exhaust studs/bolts. Start at one end and go to the other with the bolt tightening. That way, you won't get a bulge in the middle.
Status
Not open for further replies.
You have insufficient privileges to reply here.
Related Threads
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
?
ZCar Forum
posts
2.3M
members
98K
Since
1998
A forum community dedicated to Nissan and Datsun Z car owners and enthusiasts. Come join the discussion about performance, modifications, restorations, troubleshooting, maintenance, and more!
