ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
396 Posts
Discussion Starter · #1 ·
I am looking for R200 mounting hardware from a 280Z (mustache bar, and front and rear cross bars) to mount an '81-'83 R200 in my 260Z. Which year 280's had R200's? I am assuming that the differetials with the 5 bolt flange on each side where the half shafts go in are R180's . Am I correct?
 

·
Registered
Joined
·
396 Posts
Discussion Starter · #4 ·
Not all 280Z's had R200's

> I believe all 280z with manual trans. came
> with the r200. Just look under the back end
> you will be able to tell. The r200's are
> alot bigger.

> Sam 75 280z
I have seen some 280' s and 280ZX's with R180's (which have the five bolt flange around where the half shafts go in). I am still looking for a 280 with an R200 in the junkyard to grab the mounting hardware from so that I can put in a '81-'83 ZX R200 with a 3.90:1 rear end. However, I'm not sure which 280Z's (not ZX's) had the R200. I guess I will have to keep looking under 280Z's til I find one.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top