ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter #1
Heya,
I was recently involved in an accident, and my old 92 300ZXTT was totaled (<A HREF=http://www.blazen.com/z>http://www.blazen.com/z</A>/ has pix before and after. :)) Anyway, i want to
take the old motor out and put it into a 240Z. Has this been done? If so
does anyone know were i could find some info about it on the web?

Im worried that with the placement of the turbos (low and on either side), it may
be too wide...

Thanks,

-mike
 

·
Registered
Joined
·
36 Posts
Hey mike,

It has been done before, but it was in a 280z I don't know if the engine compartment dimensions are the same. In the Aug 97 issue of Turbo mag it has a 280z that had the TT setup. Try Precision Z Service at 818-716-6744, I think they did the work on the car. Good luck.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top