ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter #1
Hi,

I have one exhaust valve that I can't get to adjust. I am unable to get any clearance between the cam and the rocker. The jam and lock nut are up against each other. Any ideas? All other valves adjusted fine!
 

·
Registered
Joined
·
1,067 Posts
I ran into the same problem after I had avalve job done on mine. What I did was got some emery cloth, soaked it with WD40, removed the nut ( below the pivot ) and resurfased the bottom side of the nut. I had 4 non adjustable valves. I think that your cam really ( unfortunately) is the problem. Well good luck.
If your head was worked on, someone may have removed the cam journals, which at that piont it REALLY could be trouble.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top