ZCar Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
I have I think a Vac leak at Turbo inlet. The plastic piece behind AFM goes to turbo. Well I can pull back and forth the tube a little...its loose. Is this how it is suppose to be?? Can this cause no idle condition? If it is not suppose to be that way....How hard is it to re-tighten????
 

·
Registered
Joined
·
154 Posts
well you take off the plastic peice on the bottem of the car then if you have small hands you can get in there and put it back on i have to retighten mine once a month.
 

·
Registered
Joined
·
3,080 Posts
yes, any intake leak after the MAF will cause poor running conditions as un-metered air is entering the engine.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top