ZCar Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

· Registered
Joined
·
107,597 Posts
Discussion Starter · #1 ·
What is the best way to remove the stock bushings from a mustache bar to install new urethane ones?

Is the 81-83 zx non-turbo 5-speed the same length as the 240Z 4-speed?

Thanks
 

· Registered
Joined
·
107,597 Posts
Discussion Starter · #3 ·
> What is the best way to remove the stock
> bushings from a mustache bar to install new
> urethane ones?
I took mine down to my friends Z Sop and he pressed them out with a 14 ton press and a cylinder he had made from I forget what kind of metal. Any way he did those and the rear control arms for me.

> Is the 81-83 zx non-turbo 5-speed the same
> length as the 240Z 4-speed?
I put one in mine and it looked tad shorter to me.

> Thanks
 

· Registered
Joined
·
107,597 Posts
Discussion Starter · #4 ·
> What is the best way to remove the stock
> bushings from a mustache bar to install new
> urethane ones?
Like 240Dave said, burn them. I used a 3/8 drillbit, I think, and drilled through the rubber all around, then used vicegrips to pull the center portion out, then burned the rest with charcoal lighter and a propane torch.
Mike
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top