Turn Signals

The emerg flashers are in the same can as the reg flashers. I'd read the message to newbies post. Pay a visit to xenons130.com, download the service manual there for free. Check to see if you have 12v TO the switch. Sometimes you need to pull the swicth, open it up and clean the contacts, but the fact that you have no turn signal nor flashers tells me that either you are not getting 12 v to it ot the flashers itself is bad. Can you jump a wire to the turn signal lights?

Thanks for the reply.The flasher is new.If I use my 12volt light to probe the plug should I be getting voltage at least to the plug itself?I have the Chiltons manual but it is really lacking in testing.I have had this Z for 15 yrs and I am still learning.I just replaced all my injectors for the second time and every pump and piece in the engine bay at least once or twice.I thought I had the service manual but naturally I can't find it now.

Why did you replace the injectors the second time? What was the mileage on them? Where are you located?

One of the injectors on #3 was leaking.Last changed them about 10yrs ago.All of them had splits in the rubber lines to the fuel rail so I just changed them all at the same time.I am in Pensacola fl.