ZCar Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
187 Posts
Discussion Starter #1
Will turbo injectors work with a non turbo ECU? How much HP will non turbo injectors be up to. KIRK
 

·
Registered
Joined
·
994 Posts
might work if you,,,

use a turbo flowmeter,fuel pump and fuel pressure regulator....with added fuel you need more air...so witrh the turbo flowmeter you will get the air you need...you would need to swap the insides from the non turbo flowmeter into the turbo flowmeter so your harness from your car will plug into the turbo flowmeter...dont really know how much hp the injectors are good till but 250 should be about right..see ya jim
 

·
Premium Member
Joined
·
40,978 Posts
Don't bother!

The stockers are good for just about anything you can throw at them, you just need to be able to get the pulsewidth, which means stand alone EFI.

Our land speed record holding 280Z has 37# injectors. Take a look at the stockers and see if you really need those injectors.

To answer the question, they will work, but the O2 sensor can only trim 10%, so you will have to bias fuel pressure to trim the thing so you are not running super rich on the low end.

If you are thinking about doing this swap, spend the money for the A/F ratio meter with the four-wire wide-band O2 sensor. You will find it invaluable for tuning.
That, and a G-Tech...
 

·
Registered
Joined
·
1,244 Posts
Re: Don't bother!

Tony is right.
Plus the fuel pressure regulators are the same for both the ZX and ZXT's

Donna
 

·
Premium Member
Joined
·
40,978 Posts
Oooooh! I hate validation!

Common sense is such a bummer!
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top