ZCar Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
on a 1983 n\a can I cut out the exsess metal in between the intake tubes.
this way I can wrap them in fiberglass heat wrap to cut down temp???????????????????? thanxz If I did this would the manifold be prone to crack??
 

·
Registered
Joined
·
4,687 Posts
I seriously think this is a waste of time and effort. Yes you can do it, the easier solution is to get an early intake that doesn't have the webbing or better yet, just insulate the heat shield that's already there.
 

·
Registered
Joined
·
5,854 Posts
The whole reason the webbing is there is to cut down on heat to the injectors. Make sure your heat shield is there between the intake and exhaust manifolds.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top