ZCar Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
Hey Guy's
I just have a few ?'s that i need answered. Will a 280 zx coupe 5 speed work fine in a 2800 zx 2+2. If not what will I have to change. I don't think my existing clutch will be a problem but I didn't know about the drive shaft or anything else, also if the clutch will be a problem can I just install the clutch off of the coupe as well. thanx for all of your time and help

Cole
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #2 ·
> Hey Guy's
> I just have a few ?'s that i need answered.
> Will a 280 zx coupe 5 speed work fine in a
> 2800 zx 2+2. If not what will I have to
> change. I don't think my existing clutch
> will be a problem but I didn't know about
> the drive shaft or anything else, also if
> the clutch will be a problem can I just
> install the clutch off of the coupe as well.
> thanx for all of your time and help

> Cole
I had no problems putting a 82 coupe tranny into my 79 2+2, you will have to use the 2+2 driveshaft as the wheel base on the 2+2'S are a little longer.
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #3 ·
> Hey Guy's
> I just have a few ?'s that i need answered.
> Will a 280 zx coupe 5 speed work fine in a
> 2800 zx 2+2. If not what will I have to
> change. I don't think my existing clutch
> will be a problem but I didn't know about
> the drive shaft or anything else, also if
> the clutch will be a problem can I just
> install the clutch off of the coupe as well.
> thanx for all of your time and help

> Cole
Cole, the trans will work, the clutch will also work, but!!!!!!! make sure that you use the 2+2
throw out bearing sleeve with the 2+2 clutch/pressureplate setup. Or else, you will do the job twice! Good luck, Joe
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top