ZCar Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

· Registered
Joined
·
7,392 Posts
Discussion Starter · #1 ·
Ok I'm going to be getting a '77 280Z pretty soon(unless some freak event happens) its got a bad motor and an automatic tranny. I got a '83ZXT with auto tranny waiting to be swaped out. So I'm guessing the Turbo tranny is better tranny for the application, is it 100% compatable with the '77 chassis? are the few wires coming from it the same?

I am also thinking of sticking a manual tranny from a 280ZX(more than likey a '79 thats the only one I can find) in along with the turbo motor I need a stronger clutch right? It should be a direct bolt-in correct? Which leads to my next question, is the 280ZX clutch pedal and master cylinder compatable with the 280Z chassis? I hope so, cause I dont know of any early Zs in any junk yards around here and thats probably all I will be able to find.


Justin T
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top