ZCar Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter #1
I'm trying to pull off the tranny front cover to replace the seal, I think it may be leaking around there. all the bolts are out... wont budge, dont know if theres something in the guts thats holding it on or what. Theres a little bit of fluid soaked in the bottom of the bell housing, could it be from that seal? or the shaft seal (which they couldn't locate at nissan) thanks
--Casey 280zx 83' 5-speed
 

·
Registered
Joined
·
1,041 Posts
Yours should be similar to my 4-sp. There is a split retaining ring on the shaft right where it exits the cover. That and a plastic mallet for a few whacks from the back and it should break free.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top