[1 Z]

hey guys, ok i got my z running good but, the only thing is that when i start it it'll start but only for bout a min. then die,if i leave my foot on the gas it'll stay on.it was giving me a code maf,but i sprayed some maf cleaner did not get it again. but still does it,and no codes but 55.my tps is at 4.6v but if i disconnect it it'll stay on but at higher rpms.Its got new oem fuel inj. new o-rings,new iavc,new aac valve,new o2 sensors,my fuel pump is about 3 yrs. old fuel filter also, new fpr.what could cause this? thanks

 

[KyleKidd]

Was maf the only code?
If so i would start there. Unplug the maf and see if the plugs are corroded. They will be all green and gross. If its gunked up clean it.

and TPS is suppose to be at .38 (might be .48 I'm having trouble remembering at the moment) volts also. 4.6 is way too high! mine doesn't even go over 4.1 Volts.

 

[JT240Z]

Yep, .48 volts at closed throttle. It’s definitely not supposed to be set at 4.6V unless you’re measuring across the wrong two wires.