ZCar Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter #1
Putting a new timing belt on the VG30, had a headgasket go out. The white marks do not line up with the punch marks on the cam pulley. I can move the cams to line up the white marks on the Gates belt, then they don't line up with the backing plate marks.
Al
 

·
Registered
Joined
·
7,924 Posts
Make sure your using the right lines on the belt. The dotted line should go to the left cam pulley, the two solid lines go to the right pulley and crank pulley.
 

·
Registered
Joined
·
7,924 Posts
yeah. arrows point away from the engine. The dotted line goes on the left (passenger) cam, the first solid goes on the right (driver) cam and the second solid lines goes on the crank. once this is done, all dots and marks should line up properly.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top