Throttle shaft leak on SU's how to fix?

I used to work for Fuel Systems Specilities and we did these all the time. We would drill out the shaft hole and epoxy in teflon bushing then using valve reamers, size to fit.

I'd look at teflon or nylon bushing that are that size. If you have bushings already, you might be able to replace them.

You might try a new shaft, depending on if the shaft is worn or not. Also, swaping the bodies might work too.

Good Luck, KarlJay.

You are SOL
you will need to get them machined to alllow for the bearings to be pressed in, too much hassle

Thanks for the responses.

I was hoping someone would say just use RTV Silicone...it worked for me.

Time to send them down to Salem!

-Hugh