ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2,096 Posts
Discussion Starter · #1 ·
Hey, I was looking at my 78 280z engine thinking of ways to clean it up appearance wise, I noticed that the thermal vaccum valve is ugly, and it is apparently only to operate the EGR system, my EGR is inop anyway, I already removed the BPT valve. Can I take this bad boy off my engine? Im thinkin that I can if I just block off or remove the coolant lines that run to it. Or I may be lazy and leave the inoperable POS on there. Anyone think it would be a bad Idea/waste of time?
 

·
Registered
Joined
·
130 Posts
I'm looking at trhe same thing. I have just started research. Shoot me an e-mail and we can try to figure it out. Right now I believe I will remove it. I just have to decide how to change the plumbing on the passenger side for it to look good and work.

Cliff
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top