ZCar Forum banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Registered
Joined
·
1,359 Posts
Discussion Starter #1
i really like the smoke tint on the turbo z's rear lights... mine is a n.a though. i was wondering, has anyone dried like spraying on a smoke tint to the rear lights of a n.a? just a thoght i have considered before i rack out the money for a new turbo rear light assembly.
 

·
Registered
Joined
·
297 Posts
i haven't dried at all, personally. it's been quite rainy in seattle.
 

·
Registered
Joined
·
1,991 Posts
You can use the Technique I used. Get Pinstripeing that is two same thickness lines, and stripe over the top of the cover working youre way down, and Spacing evenly. Mine has been like this for 6 years, very nice looking, and you can hardly tell.


"Blackouts"




Post Edited (Nov 14, 5:10pm)
 

·
Registered
Joined
·
1,359 Posts
Discussion Starter #4
sounds like a tight idea, but mine has the earlier light style. i dont know if it would look right.
 

·
Registered
Joined
·
5,401 Posts
Nah window tint wont work, at least not very well because of the raised lettering on the tail lights which will cause mega bubbles. Way around that is to get a mould done without the raised lettering, use spray or if you really have the time take the light apart and then use window tint on the INSIDE of the light. Probably would look better then aswell...
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top