ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
486 Posts
Discussion Starter #1
I just ordered a complete seat of bushings for my 72 240z. They are all polyurethane. My question is, the rear outer bushings have that pin that runs through them, what is the easiest way to remove that? Pount it out and buy a new one, or use a slide hammer retrofitted to pull it out.
Thanks,
Joshua L.
 

·
Registered
Joined
·
1,582 Posts
> I just ordered a complete seat of bushings
> for my 72 240z. They are all polyurethane.
> My question is, the rear outer bushings have
> that pin that runs through them, what is the
> easiest way to remove that? Pount it out and
> buy a new one, or use a slide hammer
> retrofitted to pull it out.

A replacement pin should be included in your bushing kit. Just throw the old one in the tickle box.

Doug Dawson
[email protected]
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top