ZCar Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

· Registered
Joined
·
646 Posts
Discussion Starter · #1 ·
Well my problem is with the strange idea of Datsun to put a seat and seatbelt safety swith on the 260. You must be sitting in the seat with the belt on or the car will not start. I would like to disable this feature without causing any electrical problems. I tried disconnecting the wires to the belt and seat with no luck. I then tried to jumper the wires together with no luck. I then put a meter on them and found 12V going to the seat and belt! If I ground on of the wires, I see a nice spark and hear the relay in my engine compartment click. This fixes the problem, but could potentialy drain my battery. I have no idea what the other wire is for. If anyone has any ideas of how to bypass the system altogether or however, I would appreciate it.

Thanks,

Jason
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top