ZCar Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter · #1 ·
ok my ecu,crank angle sensor,ignition module "transistor thing"and coil are all good,i tested the plug that goes into the coil and there is power to the coil but when i plug it into the coil there is no power this car is driving me insane!!!87t auto
 

·
Registered
Joined
·
1,839 Posts
use your ohmmeter and connect pos. to any of the three coil terminals. connect neg. to the coil frame. if you show any reading at all from any of the terminals you have an internal short to ground and the coil is bad.
 

·
Registered
Joined
·
107 Posts
Discussion Starter · #4 ·
thanks guys i gave her a tune up and she runs again i guess it was just a bad wire drove me nuts though now i can finish converting over to a 5 speed
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top