ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter #1
ok i took the ignition module,ecu,distributor and coil from my 87t and put it in my 86t and each one works fine,fusible link and all fuses are all good but im still not getting any spark in the 87 how could i test to see if power is coming from the battery?
 

·
Registered
Joined
·
880 Posts
use a dmm to check for a signal from the distributor/crank sensor while cranking the engine.. if you get a signal go to the ecu and test that pin. then go test for power to the module, then test the coil.. coil wire.. i think it would be easier to help if ya had some more details, like where you do and do not have power. good luck, im at war with my ignition too.. just wired in my msd coil, now i have to test the module.. good luck~
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top