ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
152 Posts
Discussion Starter #1
Is there ia trick to get the steering rack strap back on when you install new bushings? I can not get the back hole on either side to line up. Also, does the steering wheel need to be straight?
Any help would be greatly appreciated.
Dan
 

·
Registered
Joined
·
664 Posts
Not sure about this but on my 76 I unbolted the engine mounts then put a small piece of wood on my hydraulic jack under the oil pan and lifted the engine an inch.
Once up you can put a piece of 2x4 in between the mount and frame to hold it up.
This allows for plenty of manuverability underneath.This works good too when replacing the oil pan gasket. Preferably the wheel should be straight but probably doesnt matter.
Ron
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top