ZCar Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Team,
Working on rebuilding my steering I found the replacement Gates O-rings from several vendors aren’t fitting on the steering column of my 1983 280zx turbo 2+2

Below are the specs:
Rack ID = 2.049”
Shaft OD = 2.0437”
Groove OD = 1.845”
Groove Width = 0.084”
Seals (bottom) Width = 0.084”
O-ring Width = 0.057”

Has anyone had this issue? Any idea the cause? If so, what is the solution?
 
1 - 1 of 1 Posts
Top