ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
262 Posts
Discussion Starter #1
the Rear half of my front right splash guard popped out about a week ago, i'v been trying to get it back on but there arn't any plastic plug holes on the fender, and the screws holding the guard on inside the wheel well are all missing, i'v tried to replace the screw's but i can't find a size that fit's, also the plug holes that should be attached to the fender seem to be ripped off, i'v tried to screw new holes into the underbody of the wheel well, manually and with a power drill but i just can't seem to punch through. Any other suggestions?
 

·
Registered
Joined
·
1,959 Posts
Use a washer or 2 with a nut or 2 on a bolt......Should work out fine if you dont mind putting something like that on........
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top