ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
I've got an83zx n/a with a manual 5 speed. I just put in a 3.7 lsd from an 88 300zx. My car supposedly had a 3.9 rear end in it - the strange thing is that my power band is about 600-700 rpm LOWER than before, which is the opposite of what it should be.

I bought a blue/18 tooth speedo cable drive gear and put it in. The old one was red and bigger in diameter, so the new gear doesn't touch & mesh with the output shaft of the tranny. I'm assuming that I will need a different carrier for the new gear that has an offset - so the gear will be closer to the output shaft and thus mesh with it. Anyone out there deal with this before? Thanks-Doug
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top