ZCar Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

· Registered
Joined
·
651 Posts
Discussion Starter · #1 ·
I'm looking to mount my kumhos on a set of steel wheels (cost being the driving factor here). Does anyone have a source/supplier for a set of 14X7s with a 4 lug and 4.5 inch bolt pattern and zero offset? If I hit the lottery, then its' panasports or revolutions, but until then, steel's the answer...
 

· Registered
Joined
·
1,910 Posts
Has anybody seen any steel wheels like this with a 7" width?

I've only seen the stock wheels which are about 5.5" wide; or, old Mercury Comet rims about the same ( but w/ the valve hole located at 90 degr. diff.).
 

· Registered
Joined
·
651 Posts
Discussion Starter · #3 ·
There a company in NC that has 6 of them (14X7) only there's 2 of us in the New England Z club that need them. They are available but in very limited supply. I was hoping someone else had a source (for at least 2 more...)
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top