ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter #1
I have a '79 280ZX 2+2: the shocks are pretty worn and are stiff by design. Since I use this as a daily driver and don't race or drive ir particularly hard, I was wondering how difficult it would be to replace the stock shocks to get a smoother ride. How much might this cost and where would I get the components? Thanks so much.

JB
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter #2
> I have a '79 280ZX 2+2: the shocks are
> pretty worn and are stiff by design. Since I
> use this as a daily driver and don't race or
> drive ir particularly hard, I was wondering
> how difficult it would be to replace the
> stock shocks to get a smoother ride. How
> much might this cost and where would I get
> the components? Thanks so much.

> JB

Hi JB,

I'm near the end of an almost complete urethane, Tokico, and all front tie rods
and ball joints project on My '79 280zx 2+2. When I get finished I'll post my subjective comments.
Price in parts is at $560 us

Regards, Bob
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top