ZCar Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
340 Posts
Discussion Starter #1
Ok, I was taking off my starter and I tried measuring the width of the flywheel teeth with a small wrench (small enough to fit in between the teeth and still have room) In the process of pulling it out, my fingers slipped and the wrench fell into the bellhousing :eek:/ !!!!! I **** near jammed my whole hand into that starter hole and can't seem to find it!!! How the heck do I get it outta there, without having to drop my tranny?
 

·
Registered
Joined
·
3,080 Posts
maybe find a magnet that will fit?

Or a really long needle nose pliars?

Or tip your car upside down carefully?
 

·
Registered
Joined
·
1,593 Posts
^^^^^^^^^^^^^^
2nd, just back the tranny off.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top