ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
574 Posts
Discussion Starter · #1 ·
well i just installed my 12" k&n cone...and i made all the stuff myself..and it seems a little loose...i bent the long bar that holds the stock air box in my 81 n/a and then i drilled a hole in my pipe with a bolt attaching the 2...but this is all that holds it in...just seems a bit loose..how do u guys have yours secured?..

p.s. im keeping my stock airbox in my hatch for the drive tomorrow
 

· Registered
Joined
·
1,078 Posts
Hi!

Sorry I don't have a 280ZX but on my 240Z i had a similar problem. I drilled 2 small holes (1 will do) just behind the radiator frame and the cone is held by strong wire going round it and passing through the small holes I made on the frame.

Hasn't dropped off yet and I don't think it will.

Just my 0.02 cents.

Good luck.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top