ZCar Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Tried dropping the transmission and it hits on the aftermarket exhaust a previous owner put on. I have one broken header bolt so I figured this would be a good time to address that. I've never removed either and was wondering if there is a write up online? Basic searches didn't reveal anything.

Any tips or tricks? Possible problems to look out for?

Besides a new gasket and header bolts anything else I should look into or address while I'm at it?

Thanks guys.
 

·
Registered
Joined
·
233 Posts
Search, they are out there. But in all reality any of the early manuals will cover what you are doing. I have a early Z (12/70) and have used a 1973 FSM and a Haynes manual to do everything over the last 20 years.
 

·
Registered
Joined
·
997 Posts
spray a lot of PB blaster on all the studs and bolts..
 
1 - 5 of 5 Posts
Top