ZCar Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter #1
Hi, I am in the process of beginning to remove my rear axle and suspension assembly on my '71 240Z. The car is supported by jack stands resting on the sides of the front diff. mount cross member. I know the diff front member needs to come out in order to remove the entire assembly. I can see that two of the installation bolts for the front member bolt into the support that I have the car jacked up on - I assume I can safely remove the entire assembly using a hydraulic floor jack located underneath the gear carrier after diconnecting the assembly?

Thanks,
Z
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top