ZCar Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
2,227 Posts
Discussion Starter #1
I'm currently removing the Front Exhaust tube on my 85na as a part of the clutch replacement that I'm doing.

**** those bolts are rusted on there good! I was able to loosen one bolt of the two where it meets the cat converter and one of the three that connect the front exhaust tube near the exhaust manifold.

The rest are stuck on there good and I hit them a dozen and more times with PB yesterday and I'm going to do it again today.

I was wondering if there was any other advice/tips anyone might have.

I'll take anything I can get - what a pain in the ass!



Post Edited (Mar 21, 8:02am)
 

·
Registered
Joined
·
657 Posts
get yourself a torch...... id get one of the little butane ones.... theyre really small, and you shouldnt have any problems fitting it anywhere. just heat the area around the bolt.
 

·
Registered
Joined
·
2,227 Posts
Discussion Starter #3
Thanks! Depending on the price of the torch I may pick one up as these aren't the last of the bolts that I will have to struggle with.

I'm going to take the front drivers side tire off tonight for easier access to those 3 bolts as well. Stu vs. 20 years of rust!
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top