ZCar Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter #1
I see that in the top the panels are connected by plastic rivets and I have taken all of those out
and before I go any further I want to know what I'm doing. It's my first Z and I'm afraid I'm going to break them if I try to force them. Any help would be great. Thanks.
 

·
Registered
Joined
·
247 Posts
>OK here it is according to the Haynes manual.

Remove interior trim panels
disconnect the connector plugs
remove the liceense plate lamp securing screws
drive out the center of the plastic rivits
remove screws that secure the lens unit to the body shell and withdraw the unit.
Good luck
Craig
76 280Z
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top