ZCar Forum banner

Status
Not open for further replies.
1 - 16 of 16 Posts

·
Registered
Joined
·
14,897 Posts
Discussion Starter #1
All you guys who got an early version of the BMC brace...email me. I will send you the final version with slotted holes and a set-screw option.

 

·
Registered
Joined
·
14,897 Posts
Discussion Starter #4
I think you got an early version...round holes.

Guess what...the Hawks squeal now and then...look at my thread below.

(I'll still replace an early version for you)
 

·
Registered
Joined
·
11,803 Posts
Which Hawk pad did you end up using?

The HP+'s squeal pretty bad and are REALLY hard on the rotors. The HPS's tend to squeal as well but are a little more rotor friendly. If you used any of the race pad series, then you'll really have problems with squealing and dusting.

I have a set of PBR (Axxis) ceramics if you need them. They're new and never used. My plan is to use Porterfield R4-S pads instead. I'll give you a good deal on the new pads.



Post Edited (Jan 30, 9:02am)
 

·
Registered
Joined
·
6,813 Posts
If I'm not sure about what hardware is on my

car -- can I drive it down to the local MegaZ dealership and will they do a free inspection to see if I need the improved part?

When I buy something from you in the future can I fill out one of those little registration cards so you can contact me in the future if new problems come up?

LOL -- having some fun here....

;-)



Post Edited (Jan 30, 8:02pm)
 

·
Registered
Joined
·
3,584 Posts
I didn't know you got Hawks... The pads I sent you were Axxis Ulitmates! Squealed like a MoFo for me too... But you could sure notice the stopping power!
 
1 - 16 of 16 Posts
Status
Not open for further replies.
Top