ZCar Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
I have ALL the parts for the Ram Air Induction system that was on this web address

<A HREF=http://www.newtier.com/graber/z-car/Air-Intake-Project/index.html>http://www.newtier.com/graber/z-car/Air-Intake-Project/index.html</A>

But now that I finally get a day off to put it all together... the web sight isn't working..
How do I put this thing together? I've tried for over 2 hours now and I need some advice.
I have a 1981 280zx. Has anybody else done this out there?
Thank you for any advice.
Jamison
 

·
Registered
Joined
·
214 Posts
ok.. its easy..

do something like this:

glue or screw the angles and the stragit piece of pipe together.. stick the filter on the end of the straight piece and clamp it down or what ever you going to use ti stick er together.. then take the clamp off the rubber piece and slide the angled pipe over that.. now get something that will work as a mount.. theres things at hardware stores that have lots of holes and are metal. those work the best. any more ? email me

will

300cc.hypermart.net
 

·
Registered
Joined
·
107,695 Posts
Home Depot has a good selection of abs
pipes and couplings to buy. I bought a 2.5
long by 3 inch wide coupling and the pipes. You first dry fit everything, by the way I also changed my Air Flow Meter to a 3 inch turbo model at the same time to get everything adjusted at once. Press the elbows and pipes together and when you are satisfied with the geometry drill a small whole through both the pipes and install sheet metal screws.

Thats how I did mine and it was harder to adjust
my air flow meter and air bypass.

Lui280z
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top