ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
247 Posts
Discussion Starter · #1 ·
First off thank you for your clear and consise response to my earlier question on compression, it was very helpful. It did however spark another question which is:
Do I have to worry about the piston clearance if I go with the 83 block and the 76 head. Are there any special instructions to follow or pitfalls to watch out for when doing this modification?

Thanks for all your expert advice.
Craig76Z
 

·
Registered
Joined
·
1,610 Posts
Craig,
There should be no problem with valve/piston clearance in using any head on any block as long as they aren't shaved to increase compression ratio even more.
Phantom
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top