[Nitrouz boy]

Do I need tha halfshafts off the R200 or do I use my halfshafts? From what I understand the r200 shafts are too long to fit the 240. To i just pull the shaft out of the r180 and slide it right in?Thanks, NB

 

[Unknown User]

I did the same identical swap using my old 180 shafts. I thought it would be too tight but it's ok so far.One point, the left side is hard to install because it wont colapse enough to fit and you will either have to undo the strut from the tower or leave the moustache bar off untill the shafts are in.

 

[joeytekno]

but you are supposed to use the R200 halfshafts arent you? i am about to do this swap.. shoot i was sposed to do it today.. i have the axles and the rear

 

[Unknown User]

I though so as well but the 240 shafts work, they're just a bit more of a pain to install.