ZCar Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
Hi folks,
Getting ready to do some work on this outstanding 77 I just purchased. It is a bit of a mutt as it has an 81 block, 79 head, 83 transmission and a 79 rear end. There are three sensors at the front of the head. One appears to be for the temperature gauge as it is a bullet style connector. The other two have the F.I. harness and connectors. I am assuming they are the water temperature sensor and the thermotime sensor, both for the F.I.

My question is: Am I safe to assume that since the brain box is a 77, when I order the two sensors I should order them for a 77 even though the head is a 79? I am also wondering if it even matters since the sensors may be the same for both the 77 and 79? Thanks for your input. John. JML 77 280Z
 

·
Registered
Joined
·
147 Posts
The part numbers are the same for those years in Victoria British catalog. I would check the sensors out before replacing. Clean the connectors and check resistance per factory manual. They may be ok.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top