ZCar Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
hello z drivers.
recently i had the engine rebuilded on my n/a '81 280zx. ever since then i have noticed a slight shaking of the engine(when on ofcourse).When i stated the engine for the first time, I noticed that the #3 valve was getting stuck.this lead to valve knocking. I had the valves adjusted and it cured the knocking. but the shacking is still felt. it feels like a small stumble every other engine revolution.specially at idle. i've check for vaccum leaks and found none. is there any way to check if the valves are sealling properly?.
by the way i have a p79 head,with a f54 block.
mario
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top