ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter #1
Through some checked I have found my power window motor works great, the problem appears to be in teh switch BUT it doesn't matter rather I am trying from the driver's door or the passneger door, the window will not roll up - it will go down but not up. Does the passsenger side switch somehow open the circuit if it is bad?

BOB
 

·
Registered
Joined
·
1,298 Posts
Are you sure it's the switch and not the wire connecting the "up" part of the switch to the motor?

As far as checking to see if the passenger switch opens or closes part of the circuit, and therefore overriding the drivers switch, best way to check that is to put a test light on the circuit and run through the permutations of the switch combinations. You might also check continuity between the two.

I would first check AT the motor for a bad connection or ground, or something specific to the UP movement.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top