ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
345 Posts
Discussion Starter #1
Hi everyone, i was just wondering if it's possible to build up an engine with negative deck height about 1.4 mm.I know CR will drop,but this is not an issue.Is it possible or i will face consequence such as not reliable engine?Thanks!
 

·
Registered
Joined
·
4,034 Posts
I think that would give less turbulance during compression and cause the air/fuel mixture to not mix properly. Unless you have a turbine to force air induct
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top