ZCar Forum banner

Status
Not open for further replies.
1 - 12 of 12 Posts

·
Registered
Joined
·
1,991 Posts
Discussion Starter #1




As of so far... The intake has been machined down 7MM. The engine has been lowered 1 inch. Does not hit the hood. Not real hard to do so far. My "Secret Special Z31 Turbo Part" is not finished yet, but allows the turbo to be installed without hitting frame. I dont know if lowering the engine allows the turbo the hit the framerail because mine is off. but by measuring the distance to the frame rail, I can see how it could be difficult to fit a larger compressor (turbo) between the engine and the framerail, use the Pathy intake, AND clear the hood without hood modification (holes) I am trying to change that.....Keep checking my posts.. Z-ya



Post Edited (Jun 27, 11:59am)
 

·
Registered
Joined
·
1,991 Posts
Discussion Starter #6
Still not sure if I am even using this intake! My Z is still down, waiting for parts. and I thought it would be fun to see what I needed to use this, and to make it clear the hood. The custom intake I am making is using a 75mm throttlebody from a mustang. This inatake will have a 240 sx on it.
 

·
Registered
Joined
·
297 Posts
if you aren't going to use it you should sell it *cough me cough*
 

·
Registered
Joined
·
297 Posts
1 - 12 of 12 Posts
Status
Not open for further replies.
Top