ZCar Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
260 Posts
Discussion Starter #1
Have any of you guys tried the nology wire on your ZX n/a or turbo? What was the results
 

·
Registered
Joined
·
335 Posts
Bosch... DONT GET THEM! Screw Autozone! I'm looking at either just going back to stock or getting the Accell 8.8 wires. I think the # is 7773.
 

·
Registered
Joined
·
2,953 Posts
ive always gone with stock. *shrug*
 

·
Registered
Joined
·
880 Posts
Sorry i dont usually post on this board but i gotta tell you stock wires would be better than Nology! enough said! 8mm or 8.5mm msd's would work just fine on a turbo motor ! I presonally run 10mmTaylor!



Post Edited (Mar 30, 10:01am)
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top