ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
I'm looking to replace my coil in my 78 280z. I have made some engine mods, big throat, header, 2 1/2 exh.system, flat tops. It's a good running car with a stock orig. coil. Any suggestions?
 

·
Registered
Joined
·
3,550 Posts
Do not get the Mallory Pro Master coil...that is DO NOT. I have one and have lost a ballast resistor so far. The car would cut out bad bad bad. Replaced the resistor and it is almost well again, not sure what it is but my insticts tell me to go back to ignition again, it pings now where it didn't before. I have had good luck with the Accel Super Coil, and wish I had got that instead. There goes my theory of keeping my ignition all vendor specific. MSD Blaster is suppose to be good too, but no personal experience.

Ken
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top