ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
685 Posts
Discussion Starter · #1 ·
Have an L28 with flattop pistons,stock but fresh bore,P/79 head with Crane 282F cam,3 angle valve job,76 style intake manifold,header from pacesetter,K/N ram air filter.I already put the bottom end together fully balanced so I sure dont want to touch it again at least for A few years.So what can I do to the head to get that much wanted COMPRESSION?

P.S.The head is apart right now and summer is coming fast.
 

·
Registered
Joined
·
107,695 Posts
Go to this web site he tells you how to rise
compression on a P/79 head. With fuel injection
you will have to adjust your airflow meter to
run richer because of the higher compression.
I think the set up of his head was 10:1.
Good luck.

>
Have an L28 with flattop pistons,stock but
> fresh bore,P/79 head with Crane 282F cam,3
> angle valve job,76 style intake
> manifold,header from pacesetter,K/N ram air
> filter.I already put the bottom end together
> fully balanced so I sure dont want to touch
> it again at least for A few years.So what
> can I do to the head to get that much wanted
> COMPRESSION?

> P.S.The head is apart right now and summer
> is coming fast.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top