ZCar Forum banner
Cancel

N/A AFM plug and Board

221 Views 1 Reply 2 Participants Last post by  dexter260z, 
D
Do all the N/A AFM's (280Z and 280ZX) have a compression connection between the connector to the ECU and the contacts on the board? I am going to do the Turbo AFM swap into my N/A and I looked at one 280zx AFM and it was soldered to the contacts on the board. I have read that you need to remove 4 screws to connector and the contacts will come off with connector. Any help would be greatly appreciated.
Save
Like
Status
Not open for further replies.
1 - 2 of 2 Posts
D
There was a post about this subject yesterday, if you look for nxmcbride you will see it and there are pics also. The connectors will seperate from the compression contacts. Look for Blue also, he has a huge tech tip section which shows you how to do it. Just be easy when seperating them, good luck.

Dexter 260z



Post Edited (Nov 11, 3:29pm)
Save
Like
1 - 2 of 2 Posts
Status
Not open for further replies.
ZCar Forum
A forum community dedicated to Nissan and Datsun Z car owners and enthusiasts. Come join the discussion about performance, modifications, restorations, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
70-83 Tech Discussion Forum 90-96 Tech Discussion Forum Car Talk Forum 84-89 Tech Discussion Forum Cars for Sale: 1970-83 240Z, 260Z, 280Z, 280ZX
Top