ZCar Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
184 Posts
Discussion Starter #1
I am finishing up a MS 2 install from Godzilla Raceworks. I have a few questions to make sure everything goes right:
1. Do I use the 0v-5v positive or 0v-5v negative wires on the wideband controller to connect to the MS ECU?
2. For those of you who are using the 30-0300 WB controller, where do you recommend I connect the ground wire around the ignition switch? I do not want to extend the existing WB wiring to the body.

The car is an 81 turbo with an 82 turbo motor and 5 speed trans.

Thanks for any help you can give me.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
145 Posts
Did you go with the wideband AFR upgrade from Godzilla? I'd reach out to them.

The Hooligan Motorsport YouTube channel has a video series of installing the Godzilla Raceworks megasquirt kit, and he did have a wideband, but don't think he went into too much detail on the install.

The Hybrid Z forum tends to have a little more traffic for the S130 platform, so it would also be beneficial to post this question there as well.

 
1 - 2 of 2 Posts
Top