ZCar Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
i have just removed the nuts conecting the moutsache bar and can't get the bvar out to replace it. I am not to happy. what do i need to do?
thanks
matt
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #2 ·
<b>RE: Moustache bar removal. Help quick!</b>

Use a prybar and pry the moustache over the studs and then slide it down . Kind of tricky huh ?
 

·
Premium Member
Joined
·
40,971 Posts
I've always taken it off by just dropping the whole assembly down with the differential and then taking it off once everything sags down as far as it will go.
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #4 ·
<b>RE: Moustache bar - another trick...</b>

Inside the car, inboard of the strut towers is a large (15/16)bolt below the floor.
Push this bolt up from below, then with the diff supported, slide the bar to the rear. With some jiggling it will just clear. At least on my 240 it does.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top