ZCar Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
932 Posts
Discussion Starter #1
Up until yesterday I had no contact from the machine shop for a week. This is definitely a case of "no news is good news." Yesterday I got a message that the crank checked out just fine and the machinist is requesting rod and main bearings. The 89mm pistons apparently fit just fine into their new bores. The motor just might make it home for the weekend. Wahoo!
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top