ZCar Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
941 Posts
Discussion Starter #1
Ok I'm getting ready to run power through the firewall and re do my terminals and grounds (and add more). I figured out that the negative terminal just grounds straight to the firewall and then the bell housing. Where do the two [positive] power cables go? Are they easy to replace if they are too corroded?

Edit: oh, and also what gauge are the positive wires. I'd like to know so I can buy the right terminal.


Thanks.



Post Edited (Jan 16, 3:24pm)
 

·
Registered
Joined
·
6,813 Posts
The thinner guage wire runs to the fuse link box located just in front of the battery (on the strut).

The thicker wire goes down to the starter (and I think the alternator?).

Not sure of the cable size -- but want to say 00 guage.



Post Edited (Jan 16, 4:56pm)
 

·
Registered
Joined
·
2,736 Posts
No.

The wire will not fit into the 4 guage hole without drilling it out but it is not that difficult to do. Use a sharp bit and put the terminal in a vice.

FYI. The cables on the 300zx are 2 guage.



Post Edited (Jan 16, 5:49pm)
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top